How to Remove the Hard Disk From an ASUS Laptop
1 Lay a cotton bath towel on a table area to protect the lid of your laptop from scratches. This towel can also catch tiny screws as you remove them from the laptop case.
2 Unplug the AC adapter and pop out the battery. Press down on the “On” button for a few seconds to bleed off any electricity that may be in the motherboard. Otherwise, when you start handling internal parts, you risk shorting out the motherboard if any stray charge or static electricity is present. To be extra cautious, ground yourself by touching a piece of metal before continuing. If you get up from the work area, ground yourself again before continuing your work.
3 Close the laptop lid. Turn the laptop over on its lid, on top of the towel, and examine the layout of the various plastic panels on the bottom of the laptop. The smaller access panels most likely cover the memory chips and the internal wireless network card. Look for a panel about the size and shape of a deck of cards, with a symbol of a hard drive embossed on the plastic.
1 Loosen and remove the small screws holding the access panel in place. Use gentle pressure if the screws seem very stubborn or tight. Avoid “stripping” the heads of the screws by using too much twisting pressure. Be careful not to use so much pressure that you crack the delicate laptop screen. Gently remove the access panel cover and set it aside, with the screws resting on the cover.
2 Examine the hard drive. If it appears to be held down in the cavity by another set of tiny screws, remove them.
3 Notice the end of the hard drive that is connected to a cable or connector head. Carefully pull the hard drive away from this connector head while the drive is in its “flat” position. Don’t bend the hard drive upwards. Use your fingers to slide the drive straight back and away from the connector until it pops free.
How to Turn Off the Keyboard in an ASUS BIOS
1 Shut down the computer and restart it.
2 Tap the “Delete” key a few times as soon as you see the ASUS logo or the initial POST screen. Wait a few seconds for the computer to display the BIOS setup menu. Enter your System Administrator password for the BIOS if prompted.
3 Press the “Left” cursor key to navigate to the “Main” menu header if not already active. Press the “Down” cursor key to scroll down to the “Halt On” or “Halt On Errors” option, then press “Enter.”
4 Scroll down to the “All but Keyboard” value option to highlight it, then press “Enter.”
5 Press the “F10” key to save the BIOS changes and restart the computer. While the computer restarts, disconnect the keyboard. Disconnect the mouse and monitor as well if needed.